AMC-HAMMER OIL is supplied in 3 grades, 150, 320 and 460 centipoises with or without Molylube additive Molybdenum disulfide – to improve the lubrication and wear characteristics of the hammer.
AUS-TROL can be used with AUS-GEL, CR- 650 and LIQUI- POL to give a complete core recovery fluid that is solids free. It can also be used to make up stiff foam in air drilling operations.
AMC-HAMMER OIL is supplied in 3 grades, 150, 320 and 460 centipoises with or without Molylube additive Molybdenum disulfide – to improve the lubrication and wear characteristics of the hammer.
Holes Size – Consumption (based on max. 35Opsi air) 3½“ to 5` – 1.5 to 2.0 litres/hour 5” to 7½“ -2.0 to 2.5 litres/hour 7 ½ “ to 8 ½ “ – 2.5 to 3.0 litres/hour 8 ½ “ to 8 ¾ “ – 3.0 to 3.5 litres/hour 8 ¾ “ to 17 ½ “ – 4.5 to 5.0 litres/hour
AUS-PLUG is a hydrophilic polymer in granular form that absorbs up to 500 times its original volume in water. AUS-PLUG is ideal for sealing zones of lost circulation and can also be used to reduce rod vibration in holes where lost returns are a problem.
AUS-PLUG should be partially pre-hydrated in fresh water or the drilling fluid before being pumped down into the cavity or when spotted across the thief zone. The mixture will swell rapidly to help seal and plug fissures, cracks and porous formations.
CR-650 is a high molecular weight, powdered polymer which has been developed to improve core recovery, particularly in broken and sandy formations. It may also be used to stabilize reactive clays and shales and to provide lubrication when diamond drilling in bad conditions.
Add to Fresh Water Under normal drilling conditions – 0.5 to 0.75 kg/1,000 litres.
To stabilize swelling clays and shales – 0.75 to 1.0 kg/1,000 litres.
To improve core recovery in sandy, friable formations and to increase hole stability – 1 to 2 kgs/1,000 litres.
CR-650 should be mixed by adding slowly through a jet tunnel or high speed stirrer.
AUS-GEL is a modified high quality grade sodium Bentonite formulated to ensure ease of mixing with superior mud making qualities in fresh water.
AUS-GEL provides viscosity and gelling to most water based fluids while also contributing to fluid loss control.
AUS-GEL is recommended as a high yielding viscosifier for building a mud system with excellent hole cleaning properties and low filtrate values in fresh to brackish water.
GYPSET is high strength cement that has been formulated to set hard in a specific time.
GYPSET is ideal for curing lost circulation and for cementing unstable, caving ground. Gypsum cements can set while being pumped, it is, therefore, important that the correct grade of material is used to provide adequate pumping time. GYPSET may also be used to cement surface casing or pipe in air drilling operations. GYPSET is available in setting times that range from 15 minutes to 120 minutes.
Its extreme pressure lubrication proper ties were designed for the operating parameters at the face of an impregnated diamond bit giving improved penetration rates and extended bit life.
AMC SUPERLUBE™ forms a protective coating on the metal surfaces. AMC SUPERLUBE™ reduces torque and frictional drag on the drill rods, minimizes wear on the drill string and protects the rods, barrel and inner-tubes. Benefits include improved cutting actions of the bit and reamer. AMC SUPERLUBE™ can be used in surface and underground mining operations.
